ANSI/AGMA 2007-C00 (R2006)

Click to enlarge $22.00

  • Model: ANSI/AGMA 2007-C00 (R2006)
  • In Stock

Add to Cart:


Gears - Surface Temper Etch Inspection After Grinding

STANDARD by American Gear Manufacturers Association,


Full Description

This standard specifies standard procedures and requirements for the detection and classification of localized overheating on ground surfaces by chemical etch methods.

Some methods which have been used in the past are no longer recommended. Specifications should be changed to use the methods in this standard. These etching methods are more sensitive to changes in surface hardness than most hardness testing methods.

This standard applies to steel parts, such as gears, shafts, splines and bearings, but is not applicable to nitrided parts and stainless steels.